Toa-electronics H-1 Uživatelský manuál

OPERATING INSTRUCTIONSH-1SPEAKER SYSTEMPlease follow the instructions in this manual to obtain the optimum results from this unit.We also recommend

Grille7. REPAINTING THE GRILLE AND TRIM PIECEFollow the procedures below to change the color of thegrille.1. Remove the speaker's ang

7. Attach the grille to the speaker with its two mountingscrews.8. Reattach the mounting bracket to the speaker with theangle adjustmen

10. SPECIFICATIONS• AccessoriesAdapter PanelPattern paperSpeaker mounting screwM4 x 25 (with spring washer andplain washer)Electrical box mounting sc

1. SAFETY PRECAUTIONS• Be sure to read the instructions in this section carefully before use.• Make sure to observe the instructions in this ma

2. GENERAL DESCRIPTIONTOA's H-1 is a cylinder-shaped, small flush-mount 2-way speaker featuring high sound quality.3. FEATURES• The H-1 Speaker

5. NOMENCLATURE[Side Panel][Front Panel][Side Panel]H-1 speakerGrilleTrim Piece[Side Panel][Rear Panel]For mounting to the Adapter PanelMounting brack

6. INSTALLATION6.1. Direct Wall/Ceiling Mounting Without Using an Electrical BoxStep 1. Adapter Panel mounting1-1. Using the supplied hole patter

1-4. Clamp the wall or ceiling panel using the two boardclamps, and secure with the clamp screws.Step 2. Wiring and impedance changes2-1. Pul

2-4. Attach two impedance selector sockets to theconnector to select the desired impedance. Preset to830 (12 W for 100 V line and 6 W for 70

Stud screw3-2. Loosen the angle adjustment screws. After adjustingthe angle, retighten the screws.TipThe mounting angle can be adjusted f

6.3. Mounting the Speaker Directly to an Electrical BoxThe H1 speaker system can also be mounted directly to an electrical box*. Follow St